ES-2121 Transmission Mounting Kit for 1939-1940 Mercury (Turbo350,PowerGlide,Manual)
Bolt on unit allows removal of transmission without pulling engine. Wishbone splitting kits have been welded to bottom plate. Fits all transmissions that measure 20 5/8″ from engine to transmission mount holes. Fits Turbo 350, powerglide and stick. Hardware and instructions included.
Installation Instructions for ES-2121 Transmission Mounting Kit for GM Turbo 350, Powerglide or Standard Transmission for 1939-1940 Mercury Car
Remove original transmission mount and center section from X member.
Do not destroy rivet holes as some are reused.
Straighten any dimples in frame around rivet holes.
Place lower plate against bottom of X center and line up with existing holes.
Ream drill to 5/16″ and bolt.
Insert center support from rear and line up with lower plate mounting hole.
Drill holes and fasten the 4 side bolts in place. Flat part faces rearward.
Place wings on top of X rails and center over existing holes. Drill to 3/8″
WARNING: This product can expose you to chemicals including nickel and urethane, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
There are no reviews yet.