Description

This Kit includes:

• Bolt on frame adapters
• Chassis Engineering engine mounts
• Thru Bolt Cushion set
• Hardware
• Instructions

Engine mounts fit:

• Chevy V8, 1958-up : 283, 302, 307, 327, 350, 400 CI Small Block
• Chevy V6 with the distributor at rear

Product Variants:

• CP-1109 Mounting Kit for 1949-1954 Chevy with original suspension
• CP-1109G Mounting Kit for 1949-1954 Chevy with Chassis Engineering IFS
• CP-1109PM Mounting Kit for 1949-1954 Chevy with non-Chassis Engineering Pinto Mustang IFS

Easy to install use this kit with aftermarket Pinto/Mustang front suspension. Weld on kits include adapters, mounts, Thru bolt cushion sets, and instructions.

Installation Instructions for CP-1109 Small Block Chevy Engine Swap Kit for 1949-1954 Chevy Car using aftermarket Pinto/Mustang suspension.

1. Remove original engine, transmission and rear end. Remove transmission cover in floor for access. Cut the two braces from inside of frame rails that interfere with engine mounting. As you progress, you will find other odd pieces that will need to be removed/trimmed for clearance and fit.

2. Slip both the frame adapters over the frame and locate as shown below.

3. Trim outside of frame adapter saddle as needed to clear spring pod of IFS

WARNING: This product can expose you to chemicals including nickel and urethane, which are known to the State of California to cause cancer and birth defects or other reproductive harm.  For more information go to www.P65Warnings.ca.gov.