Description

CP-2102 Small Block Chevy V8 Engine Mounting Kit for 1941-1948 Ford with solid axle

Engine mounting kit fits 1958- up SB Chevy V8 into 1941-1948 Ford car with a solid axle front end.

• Bolt-on frame adapters
• Chassis Engineering engine side mounts
• Thru bolt cushion set
• Hardware & Instructions

Engine mounts fit:

• Chevy V8, 1958-up : 283, 302, 307, 327, 350, 400 CI Small Block
• Chevy V6 with the distributor at rear

Product Variants:

• CP-2102 Mounting Kit for 1941-1948 Ford with solid axle
• CP-2102P Mounting Kit for 1941-1948 Ford with Chassis Engineering IFS
• CP-2102G Mounting Kit for 1941-1948 Ford with non-Chassis Engineering Pinto Mustang IFS

Installation Instructions for CP-2102 Chevy Small Block V8 Engine Swap Kit for 1941-1948 Ford Car

1. Remove original engine and transmission.

2. Place frame adapters around frame and clamp into position shown. Make sure adapters are straight and level.

3. Drill bolt holes in frame to 3/8″, and install and tighten the bolts.

4. Bolt offset engine mount to left side of engine and the standard mount to the right side.

5. Install cushion set as shown

WARNING: This product can expose you to chemicals including nickel and urethane, which are known to the State of California to cause cancer and birth defects or other reproductive harm.  For more information go to www.P65Warnings.ca.gov.