1940-1954 Chevy & GMC Truck Small Block Chevy Engine Mounting Kit

SKU: CP-1160

Description

CP-1160 Small Block Chevy (SBC) V8 Motor Mount Kit for 1940-1954 Chevy & GMC 1/2 Ton Truck     Chevy motor swap kit for to mount a small block Chevy engine in 1940-1954 Chevy Truck (1/2 ton) and/or 1940-1954 GMC Truck (1/2 ton)   Small Block Chevy Mount Kit for… Read More

Category:

$208.00
PRICE
QTY

Description

CP-1160 Small Block Chevy (SBC) V8 Motor Mount Kit for 1940-1954 Chevy & GMC 1/2 Ton Truck

 

 

Chevy motor swap kit for to mount a small block Chevy engine in 1940-1954 Chevy Truck (1/2 ton) and/or 1940-1954 GMC Truck (1/2 ton)

 

Small Block Chevy Mount Kit for 1940-1954 Chevy / GMC includes:

  • Bolt-on frame adapters
  • Side engine mounts
  • Cushion set
  • Bolts
  • Instructions

 

Small Block Chevy Motor mount kit fit:

  • Chevy V8, 1958-up : 283, 302, 307, 327, 350, 400 CI Small Block
  • Chevy V6 with the distributor at rear

 

Product Variants:

  • CP-1160 Small Block Chevy Mount Kit for 1940-1954 Chevy & GMC 1/2 tn Pickup Truck
  • CP-1160G Small Block Chevy Mount Kit for 1940-1954 Chevy & GMC 1/2 tn Pickup Truck with non-Chassis Engineering Pinto Mustang IFS
  • CP-1160P Small Block Chevy Mount Kit for 1948-1954 Chevy & GMC 1/2 tn Pickup Truck with Chassis Engineering IFS
  • CP-1160LS Chevy LS Mount Kit for 1940-1954 Chevy & GMC 1/2 tn Pickup Truck
  • CP-1160GLS Chevy LS Mount Kit for 1940-1954 Chevy & GMC 1/2 tn Pickup Truck (non-CE IFS)

 

For use with Chassis Engineering CP-1160 Small Block Chevy V8 Motor Mount Kit

Chassis Engineering Installation Instructions for CP-1160 Small Block Chevy Motor Mount Kit.

For use with original or Pacer suspension

1. Remove original engine, transmission and steering column.

2. Install mounts in frame using the following dimensions: Tap mounts in place and clamp.

3. To bolt in place, drill two holes through top lip of frame and mount. Drill two holes through bottom lip of frame. For clearance to drill bottom holes, remove front spring shackles and shocks, then drop axle down to clear. Drill 3/4″ from inner frame edge and 1″ from side edge of mount. Drill and bolt with 3/8″ bolts.

4. Point type distributor or small HEI will fit. Larger distributor will need firewall modification.

General Info: Original steering gear must be moved slightly or changed (1948-1954 only)

UntitledWARNING: This product can expose you to chemicals including nickel and urethane, which are known to the State of California to cause cancer and birth defects or other reproductive harm.  For more information go to www.P65Warnings.ca.gov.

 

Additional information

Weight 11 lbs
Dimensions 12 × 6 × 6 in

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Instruction

Download