AR-2154 Rear 4-Link for 1928-1931 Ford (Coil Over Shocks)

SKU: AR-2154

Description

Rear 4-Link for 1928-1931 Ford (Coil Over Shocks) Rear 4-Link for coil over shocks for 1928-1931 Ford, use with panhard bar. Includes: Frame brackets Four bars steel ends Urethane bushings Axle brackets with lower coil over shock mount built in Hardware & Instructions AR-2154 Rear 4-Link for 1928-1931 Ford 1.… Read More

Category:

$374.45
PRICE
QTY

Description

Rear 4-Link for 1928-1931 Ford (Coil Over Shocks) Rear 4-Link for coil over shocks for 1928-1931 Ford, use with panhard bar.

Includes: Frame brackets Four bars steel ends Urethane bushings Axle brackets with lower coil over shock mount built in Hardware & Instructions AR-2154 Rear 4-Link for 1928-1931 Ford

1. Start with rear end brackets. Spot weld brackets to rear end as shown below. Brackets are mounted 90 degrees to the ground. Set pinion 4 degrees up. Pinion should point up the same angle the crank shaft points down. Do not point pinion at transmission. Pinion and crankshaft should be on parallel lines.

2. If brackets for circle around rear end, they must be cut apart and re-welded around axle.

3. Set completed rear under car (without springs) and clamp into place. Attach front brackets to frame after double checking rear end alignment and wheel centering. Be sure all bars are adjusted the same, with 3/8 of thread showing. We have found most to be centered in the wheel opening when the axle is 1/4th inch behind original. Check!

4. Double-check installation and finish weld.

UntitledWARNING: This product can expose you to chemicals including nickel and urethane, which are known to the State of California to cause cancer and birth defects or other reproductive harm.  For more information go to www.P65Warnings.ca.gov.

Additional information

Weight 40 lbs

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Instruction

Download